Magnetic Door Holder Fitting Instructions

Watch this video to show you how to open that stubborn magnetic doorstop.

Magnetic door holder fitting instructions.

To locate the two mounting holes in the door hold the contact plate centered against the magnet open the door and press against the transfer marking points on the armature base. This may be something like a maglock or a yale door release for the installation all you re doing is connecting the door intercom to the screen and the screen with door release button to the door release mechanism meaning that you can see who s at the door and then press a button to release the lock on the door. We also sell hook auto door holder hinge pin door stop door holder overhead doorstop and door stop and hook. Place and center the door armature on the surface of the magnet with the two holes of the base aligned horizontally.

Mark the position for the keeper plate on the door. Be released thus allowing the door closers to close the doors. You can choose to buy a door floor or wall mounted spring and overhead door stop. For doors fitted with overhead closers a position towards the top of the door is best.

Place the button shaped magnet into the body section so that it sticks through the hole. Check the rubber ring is fitted before screwing the keeper plate to the door. When power is restored the magnets will re energize permitting the doors to be manually returned to their held open position. Add the spring so the narrow end sits inside the button and the wide end will sit against the plate.

Decide where the door holder will be mounted at least 650 mm from the door hinge. If you re trying to install and can t seem to get it open because its stuck. Gently close the door and adjust the angle of the door armature so the base lays flat against the door. Step 5 press the assembled catch body against the plate and turn clockwise to connect the catch body and plate together.