Average failure mileage is 1 100 miles.
Malfunction indicator light jeep compass.
The esc activation malfunction indicator light in the instrument cluster will come on when the ignition switch is turned to the on position.
The average cost for a jeep compass check engine light diagnosis testing is between 88 and 111.
The only way to know for certain why it s on is to have the diagnostic codes checked.
It lights up when the key is in the on run position before the engine starts.
Jeep compass engine malfunction warning light will illuminate then go out upon engine start up.
In some cases you need to pull over immediately to prevent damage while in others you merely need to tighten you gas cap next time you stop in order to reset the service engine soon light.
A mil that remains lit is indicative of an engine or emissions system problem.
The 2014 jeep cherokee has 1 problems reported for malfunction indicator light is on.
Malfunction indicator light or just check.
Check engine light diagnosis testing cost estimates.
It should go out with the engine running.
We would recommend you use a diagnostic tool such as the foxwell nt510 jeep obd code reader to diagnose the fault.
A check engine light can indicate a broad spectrum of problems with your 2011 jeep compass.
Labor costs are estimated between 88 and 111.
They are roughly ordered by importance which tends to be by color red amber yellow orange green blue gray but there are over 80 of them so be patient.
Click a link to learn more about each one.
The following are warning lights and indicators found in vehicles built by jeep.
Estimate does not include taxes and fees.
In rare case the engine can overheat.
The most recently reported issues are listed below.
If the esc activation malfunction indicator light comes on continuously with the engine running a malfunction has been detected in the esc system.
Jeep compass owners have reported 15 problems related to throttle control warning light on under the vehicle speed control category.